Designed and built in the Italian Apennines. A 6 mm S235JR steel differential guard, laser-cut and formed to follow the housing. The weld-on version adds no projections beyond the differential body.
is developed in-house by our technical department to increase the differential’s resistance to impacts against rock and obstacles.
Material and forming
The part is laser-cut from 6 mm S235JR steel, then formed in multiple planes to follow the geometry of the differential housing.
The forming is not only about fit: it increases the panel’s stiffness and its ability to absorb heavy impacts without transmitting them directly to the differential.
Weld-on version
The weld-on version is intended for anyone wanting protection with no projections beyond the differential profile, minimising the points that can catch on terrain.
Fitting requires only a few weld points.
Debris clearance
Slots cut into the part allow water, mud and stones to drain, preventing debris from collecting between the guard and the differential.
Designed and manufactured entirely in Italy, in our workshop in the Apennines.
Technical data
Fitment
The guard has been developed and verified on:
It is sized around the light-duty 8" differential used on the coil-sprung 70 Series variants — LJ70 / LJ73 / LJ77, RJ70 / RJ73, KZJ70 / KZJ73 / KZJ78 — also sold as Land Cruiser II, Bundera and Prado.
It is not compatible with the heavy-duty 70 Series — BJ, FJ, HJ, HZJ, PZJ, FZJ, GRJ, VDJ — which use a 9.5" front differential with a different housing geometry. The same applies to the 80 Series.
Join the expedition, join MG Off Road.
Shipping: Every guard is handcrafted in our workshop. Orders ship within 1-2 weeks. For specific requirements or urgent orders, get in touch.
You might also like